информационная безопасность
без паники и всерьез
 подробно о проектеRambler's Top100
Сетевые кракеры и правда о деле ЛевинаПортрет посетителя
BugTraq.Ru
Русский BugTraq
 Анализ криптографических сетевых... 
 Модель надежности двухузлового... 
 Специальные марковские модели надежности... 
 Три миллиона электронных замков... 
 Doom на газонокосилках 
 Умер Никлаус Вирт 
главная обзор RSN блог библиотека закон бред форум dnet о проекте
bugtraq.ru / форум / operating systems
Имя Пароль
ФОРУМ
все доски
FAQ
IRC
новые сообщения
site updates
guestbook
beginners
sysadmin
programming
operating systems
theory
web building
software
hardware
networking
law
hacking
gadgets
job
dnet
humor
miscellaneous
scrap
регистрация





Легенда:
  новое сообщение
  закрытая нитка
  новое сообщение
  в закрытой нитке
  старое сообщение
  • Напоминаю, что масса вопросов по функционированию форума снимается после прочтения его описания.
  • Новичкам также крайне полезно ознакомиться с данным документом.
А еще в Microsoft Knowledge Base написано это: 30.04.04 16:31  Число просмотров: 2226
Автор: Den <Denis> Статус: The Elderman
Отредактировано 30.04.04 16:35  Количество правок: 1
<"чистая" ссылка>
Cannot Change System Volume Drive Letter After Setup
Относится к
This article was previously published under Q223769

SUMMARY
You cannot change the drive letter of the system volume after Windows 2000 Setup is finished. The drive letter of the hard disk on which Windows is installed is hard-coded in the registry.

MORE INFORMATION

In Windows 2000, you can reassign the drive letters associated with drives after Setup runs, but not for the system volume.

If you attempt to use the Disk Management console to change the drive letters of the SYSTEM or BOOT volume, you receive the following error message:

Cannot Modify the Drive Letter of your system or boot volume.
NOTE: The boot volume is where the \Winnt folder is located, the system volume is where the boot files (boot.ini, ntdetect.com, etc.) are located.

When you are installing Windows 2000 using Winnt32.exe, you can specify the folder in which Windows should be installed by clicking Advanced Options. This option is available only when you are performing a "clean" installation of Windows.

A "clean" installation of Windows 2000 means either installing Windows 2000 on a blank hard disk, or installing Windows 2000 in a folder other than the folder in which an existing version of Windows is installed.

------------

См. русский вариант KB223188 - "Изменение буквы системного или загрузочного диска в Windows"
Подозреваю, что для w2k3 в этом плане тоже мало что изменилось.

Для w2k3 можно сделать следующее: (см. ссылку на KB830577 - "How to set the drive letter for the system drive when you install Microsoft Windows Server 2003")
Но, ИМХО, это не выход, т.к. не понятно как быть с установленными приложениями.

Изменение буквы системного или загрузочного диска в Windows
How to set the drive letter for the system drive when you install Microsoft Windows Server 2003
<operating systems> Поиск 






Rambler's Top100
Рейтинг@Mail.ru


  Copyright © 2001-2024 Dmitry Leonov   Page build time: 0 s   Design: Vadim Derkach